Komatsu — ASSEMBLY

DISASSEMBLY AND ASSEMBLY TRANSMISSION ASSEMBLY 1. Output shaft gear 1) Press fit bearing cup (43) to front housing (44). Ъ Press fit the oil seal and dust seal before assembling each clutch assembly. Ъ Press fit the bearing cup fully to the stepped portion of the housing, and check that there is no clearance. 2) Press fit bearing cone (42) to shaft (37), assemble gear (40) and snap ring (39), then press fit bearing cone (41). Ъ To prevent defective adjustment of the end play, press fit the cone as far as the shoulder of the shaft. Ъ Do not insert the snap ring into the groove.

Move it to the center, then remove gear (40) from the spline groove, and put it in the same position as the snap ring. 3) Assemble shaft (37) to front housing. Ъ Hold the shaft at an angle and insert it. 4) Install support plate to output shaft (37), and support shaft. Ъ Use the support shaft used during disassembly. 30-54 WA250-3L