FRONT CASE AND OIL PAN REMOVAL AND INSTALLATION Removal steps 6EN1898 N M 1. Oil filter 2. Oil pressure switch 3. Drain plug 4. Drain plug gasket 5. Oil pan 6. Oil screen 7. Oil screen gasket 8. Plug 9. O-ring 10. Flang bolt 11. Relief plug 12. Gasket 13. Relief spring 14. Relief plunger 15. Oil filter bracket 16. Oil filter bracket gasket H 17. Oil pump case assembly 18. Front case gasket 19. Oil pump cover 20. Oil pump drive gear 21. Oil pump driven gear 22. Crankshaft front oil seal 23. Oil pump oil seal 24. Counterbalance shaft oil seal 25. Front case 26. Counterbalance shaft, left 27. Counterbalance shaft, right 28. Counterbalance shaft, front bearing 29.
Counterbalance shaft, rear bearing, left 30. Counterbalance shaft, rear bearing, right L K G G G F E D A B J C I D E E C B A REMOVAL SERVICE POINTS A Oil pan removal MD998727 (1) Remove the all oil pan bolts. (2) Drive in the special tool between the cylinder block and oil pan. (3) Side the tool by striking the edge of the special tool to separate the oil pan from the cylinder block. 6EN0698 This alphabetical letter corresponds to the one assigned to a part in the removal, installation, disassembly or reassembly steps that are indicated in the drawing on the first page of each section. Operating procedures, cautions, etc.
on removal, installation, disassembly and reassembly are described G424 Service Manual General Information 5