Features 1. The injection pump is small and lightweight, and has a small number of component parts (compared to conventional in-line injection pumps). er Injection pump type VE Distributor type VM Distributor type PE4A In-line type PE6A In-line type Weight (kg) LengthxHeight Size (mm.) Number of 5.5 4.9 11.6 13.3. 207X181 189 x 182 293X210 347X210 196 238 326 368 Parts Remarks 2. The injection pump may be installed on the engine in either an upright or a horizontal position. 3. High speed operation up to engine speeds of 6000 r.p.m. is possible. 4.Matching of the engine's torque characteristics can be easily performed. 5. Its construction versed.
prevents fuel injection if by any chance the direction of engine rotation is re- 6. Adaption to various engine performance requirements is simplified. Control mechanisms can be independantly installed e.g. torque control device, load timer, boost compensator. 7. Because injection is stopped by turning the ignition switch (key) off, immediate stopping of the engine is possible. 8. Fuel oil lubrication (maintenance free) As lubrication of the inside of the injection pump is performed by fuel oil contained in the pump chamber, special lubricating oil is not necessary. Because of this, no time is lost through the usual inspections. EEN