ASSEMBLY Install Deck Height Pin ENGINE section.) Check Machine Safety System B Perform safety system check to make sure the electronic safety interlock circuit is functioning properly. Perform all tests. (See Testing Safety System in the OPERATING section.) A 1. Be sure mower is fully raised to the transport lock position, as shown, and insert the pin (A) in the hole just below the mower deck lift lever (B). MX37775 Install Seat 1. Remove and discard four bolts and wood block holding seat onto foot plate. B C C A D E 2. Raise seat platform (A), and install seat (B) onto platform. Secure with washers and bolts (C). MX38092 3.
Route harness connector (D) up and onto seat switch, and secure harness plug (E) into hole in seat platform. 4. Lower seat. Check Tire Pressure Check tire pressure. (See Checking Tire Pressure in the SERVICE MISCELLANEOUS section.) Adjust Mower Deck Level Adjust mower deck level. (See Adjusting Mower Deck Level in the OPERATING section.) Check Engine Oil Level Check engine oil level. (See Checking Engine Oil Level in the SERVICE Assembly - 8