OPERATING THE VEHICLE 24 PARKING ACCESSORY B Parking Brake Lever B 12V Electric Outlet The 12 volt power point is located on the front-panel. An auxiliary light or other devices may be connected to this outlet. To avoid serious injury or death: BEFORE DISMOUNTING VEHICLE A ALWAYS SET PARKING BRAKE AND LOWER ALL IMPLEMENTS TO THE GROUND. Leaving transmission in gear with the engine stopped will not prevent vehicle from rolling. A STOP THE ENGINE AND REMOVE THE KEY. C This outlet is powered when the key switch is in either the "ON" or "OFF" position. Remove accessory when not in use to avoid battery drain down.
C Do not connect a light or other device that draws more than 120 watts to this power point, or the battery may discharge very rapidly or the outlet may fail. 1. Stop the vehicle on a level surface. 2. To set the parking brake, depress the brake pedal and pull the parking brake lever to the rear engaged position. 3. To release the parking brake, depress the brake pedal, push release button and push up parking brake lever. Depressing the brake pedal makes release force smaller. Make sure that indicator in the Easy Checker(TM) goes off. A Do not use as a cigarette lighter. A Do not use when wet. A Make sure that the cap is closed when the outlet is not used.
(1) Parking brake lever (2) Release button (A) "RELEASE" (B) "PUSH" (1) 12V electric outlet B Utility Box A If the vehicle is operated with the parking brake applied, the brake will be damaged. (1) Utility Box