TROUBLES AND ACTIONS OPERATION Phenomena That Are Not Failures On The electronic Control System 0. After automatic stop, even when the work equipment has been moved 5 - 10 cm (2 - 4 in) to the front or right, it is impossible to raise the boom, pull the arm in, or operate the left offset. After automatic stop, when the work equipment has been moved 50 cm (19.7 in) to the front, the speed of the work equipment is slow when the boom is raised or the arm is pulled in.
(If the engine is running at low idle, it may even be impossi- ble to raise the boom or pull the arm in.) After automatic stop when the boom is offset to the left, if the work equipment is moved to the front to escape from the condition, and is then returned to the original position, it automatically stops on the way. (If it is offset 5 cm (2 in) to the right, it can be returned to the original posture.) After automatic stop, when the cancel switch is turned on and the work equipment is moved closer to the operator's compartment, the controller carries out self diagnosis and it becomes impossible to operate the swing or any of the work equipment. (Error code 61 is displayed.
For details, see "Electronic Control System ( 3-105 )".) When the work equipment angle sensor has been removed and installed again, the automatic stop position will change. 3-96