! WARNING ! WARNING The seat belt indicator is only a reminder and automatically extin- guishes after approximately eight sec- onds. It does not indicate that seat belts are properly secured. It is the operator’s responsibility to ensure all vehicle occupants are properly seated with seat belts secure and occupant side restraints are properly secured. Serious injury or death could occur as a result of falling outside a moving vehicle. Never activate the override switch while the throttle is open as a loss of control could result. Accelerator Pedal Press down on the pedal to increase engine RPM and vehicle speed; release the pedal to decrease engine RPM and vehicle speed. „ NOTE:
This vehicle is equipped with an RPM limiter that retards ignition timing when maximum RPM is approached. When the RPM limiter is activated, it could be mis- interpreted as a high-speed misfire. Park Indicator Light When the parking brake is applied, the indicator light will illuminate. Seat Latches 1. To remove the seat, lift up on the latch release (located at the front of the seat); then raise the front of the PR745B Headlight Switch Seat Belts This vehicle is equipped with seat belts for the operator and the passenger. To fasten and release the seat belt properly, use the following procedure. PR745C Use the headlight switch to select the high or low headlight beam.
When the switch is in the HI position, the high beam will illu- minate. When the switch is in the LO position, the low beam will illuminate. 1. Place the seat belt across your lap as low as possible without twisting the belt making sure the shoulder strap is below the neck and across the chest. Reverse Override Switch This vehicle is equipped with a reverse speed limiter system. When additional RPM is needed in reverse, depress and hold the override switch located on the center console. ! WARNING Only appropriate-sized passengers may ride in this vehicle.
Passengers must be able to place both feet flat on the floor while keeping their back against the back of the seat and hold- ing on to the hand holds. „ NOTE: The vehicle must be in 4WD to activate the reverse override. 27 2. To lock the seat into position, slide the rear of the seat into the seat retain- ers and push down firmly on the front of seat. The seat should automatically lock into position. DIVISION II - OPERATION/ MAINTENANCE ! WARNING Make sure the seats are secure before driving the vehicle. Serious injury or death could result if the seats are not properly secured.