LOADING AND TRANSPORTING THE MACHINE Incorrectly attached wire ropes may damage the machine! Only fasten the eye hooks of the carrying wire ropes at the marked attachment points. There are two attachment points each at the front part and the rear part of the machine. These attachment points are shown in the following figure. X 75_162a Information signs attached to the machine indicate the attach- ment points. To avoid damage to the machine, attach the eye hooks only to the attachment points. Machine equipment „X“: 2 Brackets, P/N. 42U-98-12A10 4 Screws M16 X 40, Strength class 10.9, P/N. 01016-51640 Screws mounted in the rear frame, inside. Tightening torque:
280 Nm When selecting the lifting equipment, take the operating weight of the machine into account. Insufficient carrying capacities of the lifting equipment may cause severe accidents. Also use car- rying wire ropes with appropriate carrying capacities for the op- erating weight of the machine. Carrying wire ropes with insufficient carrying capacities may tear when the machine is lift- ed up and cause severe accidents. The operating weight of the machine depends on the attached bucket. You find the operating weights of the machine in the chapter "Technical Data". 2-3