Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-81 Lubricating Oil Pan - Installation Rotate the engine on the rebuild stand. If a front sump aluminum oil pan is used, install the spring clip on the oil transfer tube. Install a new o-ring(s) on the oil transfer tube. Use clean 15W-40 oil to lubricate the o-rings. Install the oil transfer tube into the oil pan on rear sump oil pans. On front sump aluminum oil pans, install the straight transfer tube into the cylinder block. On front sump oil pans with block mounted suction tube, install the suction into the cylinder block by hand. Install the retaining capscrew. Torque Value:
61 [45 ft-lb] Apply a bead of silicone sealant, Part No. 3823494, to the oil pan mounting surfaces of the cylinder block to gear housing joint (1) and flywheel housing to cylinder block joint (2). Install two guide pins, Part No. 3376488, into the cylinder block.