Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-83 Rotate the camshaft slowly as it is being installed into the cylinder block. Rotate the camshaft to align the holes in the camshaft gear with the thrust plate capscrew holes in the cylinder block. Align the capscrew holes in the thrust plate with the cylinder block capscrew holes. Install the two capscrews (M10-1.50 x 25) with a nylon locking patch on the threads, or apply retaining com- pound, Part No. 3823682, to the threads. Torque Value: 47 [35 ft-lb] Remove the camshaft pilot. Use a new gasket and install the camshaft rear cover plate. Tighten the three capscrews (M10-1.50 x 22). Torque Value:
47 [35 ft-lb] Use a dial indicator gauge and a magnetic base to mea- sure the camshaft end clearance. Place the contact tip of the gauge against the face of the gear. Camshaft End Clearance mm in. 0.13 MIN 0.005 0.33 MAX 0.013