Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-88 Caution: The grooved side of the front thrust bearing must be facing toward the gear to prevent damage to the gear and engine during engine operation. Align the timing marks and install the idler gear (6), front thrust bearing (5) and gear retainer (4). Install the three retaining capscrews (M10-1.50 x 60) and tighten. Torque Value: 61 [45 ft-lb] plus 60 degrees Hydraulic Drive Idler - Installation Use Lubriplate W 105, or equivalent, to lubricate the thrust bearing and idler gear. Caution:
The grooved side of the rear thrust bearing must be facing toward the gear to prevent damage to the gear and engine during engine operation. Install the idler gear shaft (8) and rear thrust bearing (7). Caution: The grooved side of the front thrust bearing must be facing toward the gear to prevent damage to the gear and engine during engine operation. Install the idler gear (6) and front thrust bearing (5). NOTE: On SAE ‘‘B’’ drives, install a new rectangular seal on the rear surface of the gear retainer (4) before installation. Install the gear retainer (4). Install the three retaining capscrews (M10-1.50 x 60) and tighten. Torque Value: 61 [45 ft-lb] plus 60 degrees