Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-92 Install the 0.76 mm [0.030 inch] feeler gauge between the number 12 lever and the number five support. Push the number five support toward the number four support. Tighten the number five support nut. Torque Value: 47 [35 ft-lb] Install the 0.76 mm [0.030 inch] feeler gauge between the number 15 lever and the number six support. Push the number six support toward the number five support. Tighten the number six support nut. Torque Value: 47 [35 ft-lb] Measure the side clearance between the number 18 lever and seven support.
Cam Follower Side Clearance Between Supports mm in 0.76 MIN 0.030 Cylinder Head - Installation Use a ‘‘lint-free’’ cloth to clean and dry the cylinder head surfaces. Make sure all cylinder head capscrew holes are cleaned out. Install a new cylinder head gasket on the cylinder block. NOTE: The gasket can be installed with either side up.