Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-102 Static injection timing can be changed by removing the camshaft gear and installing an offset key. To change the static injection timing, remove the cam- shaft idler gear. Refer to "Idler Gears - Removal, Proce- dure 0-01". The camshaft gear puller kit, Part No. 3824106, must be assembled before use. Insert the two (1/2 x 4 inch) cam gear adapter capscrews and two plain flat washers (1) through the cam gear puller plate holes (2). Attach the two cam gear puller adapters (3) to the two cam gear adapter capscrews.
Start the (1/2 x 1 1/2 inch) capscrew (4) into the end hole (5) of the cam gear puller plate. Do not thread into the slotted hole of the puller plate at this time.