Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-109 Orient the four punch marks on the clamping ring at the 11:30 o’clock location. Apply a coating of sealant, Part No. 3823494, to the six mounting capscrews. Install the six seal capscrews (M8-1.25 X 20) and wash- ers. Tighten the capscrews in a star pattern in two steps. Torque Value: Step 1 - 7 [ 60 in-lb] 2 - 20 [180 in-lb] Place a light film of oil or anti-freeze on the inside diam- eter of the dust seal. Install the dust seal with the larger outside diameter fac- ing towards the engine. Push the dust seal back on the shaft until the entire seal contacts the oil seal case.
Vibration Damper and Crankshaft Pulley - Installation Make sure the mounting surfaces of the crankshaft nose, vibration damper and pulley are clean, dry and free of burrs. Install two guide studs, Part No. 3376696, in the crank- shaft nose. Install the vibration damper, pulley and spacer on the guide studs. Use clean 15W-40 oil to lubricate the capscrew threads and under the flange head. Install three of the mounting capscrews (M14-1.50 x 50). Remove the two guide studs and install the remaining capscrews. Torque Value: 203 [150 ft-lb]