Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-134 Water Header Plate - Installation Install two guide pins, Part No. 3376488, in the side of the cylinder block at locations (1) and (2). Use a new gasket and install the water header plate with 18 capscrews (M10-1.50 x 25). NOTE: The capscrews are not tightened to their final torque value at this time. Torque Value: 20 [15 ft-lb] Water Heater Housing - Installation Use a new gasket and install the water heater housing with four capscrews (M10-1.50 x 90). NOTE: The capscrews are not tightened to their final torque value at this time. Torque Value:
20 [15 ft-lb] Water Filter Head - Installation Use clean 15W-40 oil to lubricate the two new o-rings. Install the o-rings into the filter head. Install the filter head with two capscrews (M10-1.50 x 35) and one capscrew (M10-1.50 x 65). NOTE: The capscrews are not tightened to their final torque value at this time. Torque Value: 20 [15 ft-lb] Caution: The control valve must be in the "ON" position to prevent engine damage. Turn the control valve to the position.