Definition Of Terms Section i - Introduction M11 Page i-12 Deutsch Connector: An electrical connector Dye Penetrant Method: A method used to check for cracks in a part by using a dye penetrant and a developer. Use Part No. 3375432 Crack Detection Kit, or equivalent. End Clearance: The clearance in an assembly determined by pushing the shaft in an axial direction one way, and then pushing the shaft the other way. ECM: Electronic Control Module. E.C.S.: Emission Control System EFC: Electric Fuel Control EPA: Environmental Protection Agency EPS: Engine Position Sensor E.S.N.: Engine Serial Number ESS: Engine Speed Sensor F: Fahrenheit ft-lb: Foot Pound GPM: Gallons Per Minute GVW:
Gross Vehicle Weight Hammer: A hand tool consisting of a hard steel head on a handle. Hg: Mercury HP: Horsepower H 2 0: Water ID: Inside Diameter in-lb: Inch Pound kg: Kilograms km: Kilometers km/l: Kilometers per Liter kPa: Kilopascal l: Liter Loctite 290: A single component, anaerobic, polyester resin, liquid sealant compound that hardens between closely fitted metal surfaces producing a tough, hard bond with good characteristics. An equivalent product is Perma-Lok HL 126. Loctite 609: A single component anaerobic, liquid adhesive that meets or exceeds the re- quirements of MIL-R-46082A (MR) TYPE 1. Lubriplate 105:
A mineral oil base grease with calcium soap (2 percent to 6 percent), and zinc oxide (2 percent to 4 percent) additives. Some of the equivalent products are Loctite 601 and Permabond HL 138. m: Meter Magnetic Particle Inspection: A method of checking for cracks in either steel or iron parts. This method requires a Magnaflux machine, or an equivalent machine that imparts a mag- netic field on the part being checked. Mallet: A hand tool consisting of a soft head; either wood, plastic, lead, brass, or rawhide on a handle. MAX: Maximum allowed MIN: Minimum allowed Mini-Gen: Speed Sensor