Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-137 Lubricating Oil Cooler - Installation Install two new o-rings on the water inlet and outlet trans- fer tube ends of the oil cooler. Lubricate the o-rings with clean 15W-40 engine oil. While holding the retainer connection in place, install both o-ring adapters onto the oil cooler tube ends as far as possible. The straight edges of the o-ring adapters must face each other when installed. Install two new o-rings on the ends of the o-ring adapters. Lubricate the o-rings with clean 15W-40 engine oil. Install two new gaskets on the lubricating oil filter head.
Install the oil cooler on the engine with mounting capscrews (M10-1.50 x 30). Tighten the capscrews alternately and evenly. Torque Value: 47 [35 ft-lb] Install the four retainer connection mounting capscrews. Tighten the capscrews alternately and evenly. Torque Value: 47 [35 ft-lb]