Section 1 - Cylinder Block - Group 01 Cylinder Block (1-01) M11 Page 1-11 Use a gasket scraper to remove all gasket material and heavy dirt from the cylinder block. Place the cylinder block into a cleaning or soak tank. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam will cause serious personal injury. Steam clean the cylinder block and dry with compressed air. Make sure to blow out all oil drillings, pipe plug bores, and capscrew threads. If the cylinder block is not going to be used immediately, apply a coating of light preservative oil to prevent rust. Cover the block to prevent dirt from sticking to the oil.
Assembly Cup Plugs - Installation NOTE: Do not install any cup or pipe plugs until the inspec- tion and any necessary repair procedures are completed. This will prevent dirt from being trapped in the oil passages. Refer to Procedure 1-02 for inspection. Use cup plug sealant, Part No. 3375068, to coat the outside diameter of the cup plugs. Use expansion plug driver, Part No. 3376816 or Part No. 3822372, to install the cup plugs. Pipe Plugs - Installation Use pipe sealant, Part No. 3375066, to coat the pipe plug threads. Refer to the Plug Torque Valves’’ chart in Section V at the back of this manual for the correct torque values.