Connecting Rod - Cleaning and Inspection for Reuse (1-13) Section 1 - Cylinder Block - Group 01 M11 Page 1-42 Inspection Visually inspect the pulley for broken pieces, cracks, or excessive wear in the belt grooves. Replace the pulley if any of these conditions exist. Measure the pulley crankshaft pilot bore inside diameter. Crankshaft Pulley Crankshaft Pilot Bore I. D. mm in 32.05 MIN 1.2618 32.10 MAX 1.2638 Connecting Rod - Cleaning and Inspection for Reuse (1-13) Cleaning NOTE: The number on the connecting rod cap must be the same as the number on the rod. Do not assemble a new cap to a used rod or a used cap to a new rod. Remove the capscrews and cap from the rod. Warning:
When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam will cause serious personal injury. Use solvent or steam to clean the rod. Dry with compressed air.