Camshaft Gear - Replacement (1-17) Section 1 - Cylinder Block - Group 01 M11 Page 1-50 Measure the seven camshaft bushing journals. Camshaft Bushing Journal O. D. mm in 71.987 MIN 2.8341 72.013 MAX 2.8352 If the bushing journal outside diameters are not within specifications, the camshaft must be replaced. Camshaft Gear - Replacement (1-17) Removal Use camshaft gear puller kit, Part No. 3824106, to remove the camshaft gear from the camshaft. Install camshaft gear puller, Part No. 3824106, onto the camshaft gear. Insert the adapter (1) of the non-slotted hole in the puller plate (2) onto the camshaft gear first.
The adapter pulling surfaces (3) must point toward the center of the camshaft gear. Slide the capscrew and adapter of the slotted end of the puller plate (4) toward the end of the puller plate and insert the adapter onto the camshaft gear. The adapter pulling surface (3) must point toward the center of the camshaft gear. While holding the puller in place with one hand, tighten the capscrew on the end of the puller plate (5). Make certain the puller adapters are hooked completely over the camshaft gear. Torque the capscrew (5). Torque Value: 7 [60 in-lb] Camshaft keys are available in different sizes (amount of offset). Static injection timing is controlled by the follow- ing:
Amount of key offset. Key offset direction compared to camshaft gear rotation.