Section 1 - Cylinder Block - Group 01 Camshaft Gear - Replacement (1-17) M11 Page 1-53 Measure the camshaft gear bore inside diameter. Camshaft Gear bore I.D. mm in 46.912 MIN 1.8469 46.938 MAX 1.8479 Installation If the same camshaft and gear are used again, install a key with the same part number as the one that was re- moved. Make sure the arrow on the key is pointing in the same direction as it was when it was removed. Refer to the ‘‘Static Injection Timing’’ in Section ‘‘O’’ if the static injection timing is to be changed. Refer to the following list of offset keys to change static injection timing. The accompanying table list offset keys by part number and degree of offset.
Install the thrust plate on the camshaft. Use a soft hammer to install the camshaft key with the arrow pointing in the same direction as when it was removed.