Rocker Lever Bushing - Replacement (3-03) Section 3 - Rocker Levers - Group 03 M11 Page 3-14 Use Scotch-Brite W 7448, Part No. 3823258 or equivalent, to remove any rough edges or burrs from the bore of the rocker lever. Use solvent to clean the rocker levers. Dry with com- pressed air. Inspection If cracks in the rocker lever are suspected, refer to Rocker Lever - Magnetic Crack Inspection (3-04) Measure the inside diameter of the rocker lever bore. Rocker Lever Bore I.D. mm in 36.474 MIN 1.4359 36.499 MAX 1.4370 If the rocker lever bore is worn larger than the maximum specification the rocker lever(s) must be replaced.
Assembly The oil hole in the rocker lever bore (1) and the oil hole in the bushing (2) must be aligned correctly to supply oil to the rocker lever and rocker lever shaft. Install the rocker lever in an arbor press. Use rocker lever bushing mandrel, Part No. ST-1284, and a support to push the bushing into the rocker lever.