Cam Follower Assembly - General Information Section 4 - Cam Follower Assembly - Group 04 M11 Page 4-4 Cam Follower Assembly - General Information The cam follower group consists of the injector and valve cam followers, cam follower shafts and supports, valve push tubes and injector push rods. Label or tag all of the cam follower parts with the engine cylinder number and their relative position to the other parts as they are removed from the engine. Many of the cam follower parts are interchangeable; however, due to established wear patterns, they must be installed in the same position they were removed from.
Cam Follower Assembly - Cleaning and Inspection for Reuse (4-01) The cam follower assembly consists of two shaft assem- blies (1) and (2) installed on the engine with a common center support (3). Disassembly The cam follower levers have established wear patterns and must be installed in the same position they were removed from. Mark the end supports, front and rear, and all of the cam followers to identify their position when they are removed. The end supports are not interchangeable. Remove the end supports (1) from the shaft. Remove the valve cam followers (2), the injector cam followers (3), the valve cam followers (4), and the shaft supports (5).