Cam Follower Assembly - Rebuild (4-02) Section 4 - Cam Follower Assembly - Group 04 M11 Page 4-10 Visually inspect the cam follower levers for cracks or damage. Measure the inside diameter of the shaft bore in the cam follower levers. Shaft Bore I.D. mm in 34.086 MIN 1.3420 34.116 MAX 1.3431 If the cam follower lever is damaged or the shaft bore is not within the maximum specification, the lever(s) must be replaced. Measure the cam follower roller side clearance. Roller Side Clearance mm in 0.19 MIN 0.007 0.65 MAX 0.026 If the roller side clearance is not within the specifications, the roller must be replaced. Refer to Cam Follower Lever - Roller Replacement (4-03).
Use a dial indicator to measure the cam follower roller to pin clearance. Roller to Pin Clearance mm in 0.08 MIN 0.003 0.20 MAX 0.008 NOTE: If the roller to pin clearance is not within these speci- fications, the roller and pin must be replaced. Refer to Cam Follower Lever - Roller Replacement (4-03).