Lubricating Oil Cooler (7-07) Section 7 - Lubricating Oil System - Group 07 M11 Page 7-12 Using snap ring pliers, install the snap ring into the groove inside the bore. Install the following fittings: Turbocharger oil supply fitting (1) Torque Value: 12 [105 in-lb] Jacobs T brake supply fitting (2) Torque Value: 12 [105 in-lb] Compuchek T fitting (3). Remaining plugs Torque Value: 25 [20 ft-lb] Lubricating Oil Cooler - Cleaning and Inspection for Reuse (7-07) Cleaning Use solvent to clean the outside of the oil cooler assem- bly. Dry with compressed air. Inspection Caution: Do not reuse an oil cooler after a progressive damage failure has resulted in metal particles in the lube oil filter.
There is no practical method to clean the oil cooler core, and metal particles can be circulated through the lubricating system and cause engine damage after a repair. Visually inspect the oil cooler for cracks or damage. If cracks or damage are found, the oil cooler must be replaced.