Lubricating Oil Pump (7-08) Section 7 - Lubricating Oil System - Group 07 M11 Page 7-18 Measure the drive gear to pump body clearance. Gear to Body Clearance mm in 9.50 MIN 0.37 12.00 MAX 0.47 Use clean 15W-40 oil to lubricate the driven gear and shaft. Install the driven gear and shaft into the oil pump body. Align the dowel pins in the body with the locating holes in the cover. Install the rear cover plate and the four hex head capscrews. Alternately tighten the four hex head capscrews. Torque Value: 20 [18 ft-lb] Turn the drive gear by hand to check the shafts and gears for freedom of rotation. Measure the drive shaft end clearance in two locations 90 degrees apart.
Shaft End Clearance mm in 0.064 MIN 0.0025 0.270 MAX 0.0106 If the end clearance does not meet the specifications, the pump must be disassembled, inspected and assembled again.