Fuel Pump and Compressor Drive - Rebuild (9-02) Section 9 - Drive Units M11 Page 9-10 Drive Shaft Journal O.D. Point mm in (1) 34.984 35.000 MIN MAX 1.3773 1.3779 (2) 44.975 45.000 MIN MAX 1.7706 1.7716 (3) 47.554 47.570 MIN MAX 1.8722 1.8728 (4) 25.476 25.489 MIN MAX 1.0030 1.0035 Visually inspect the drive gear for cracked or severely worn teeth. Replace the drive gear if it is cracked or abormally worn teeth are found. Measure the inside diameter of the drive gear. Drive Gear Bore I.D. mm in 47.484 MIN 1.8694 47.509 MAX 1.8704 Measure the inside diameter of the splined coupling gear or hub coupling. Splined Coupling I.D. mm in 25.400 MIN 1.0000 25.425 MAX 1.0010 Hub Coupling I.D.
mm in 25.425 MIN 1.0010 25.438 MAX 1.0015