Section 0 - Engine Disassembly and Assembly - Group 00 Engine Disassembly (0-01) M11 Page 0-17 Remove the v-band clamp, discharge elbow and o-ring from the turbocharger compressor discharge outlet. Remove the four turbocharger mounting nuts. Remove the turbocharger and gasket. Plug the supply and drain holes in the turbocharger. Exhaust Manifold - Removal Caution: The exhaust manifold assembly has three sec- tions which can separate and fall causing personal injury during removal. Hold the assembly on each end to re- move it. Remove one capscrew from each end section of the ex- haust manifold and install two guide pins, Part No. 3376488. Remove the remaining capscrews.
Remove the exhaust manifold, gaskets and the two guide pins. Air Intake Manifold - Removal Remove the intake manifold pressure sensor and the intake manifold temperature sensor wire connectors from the top rear end of the intake manifold. Tag the wires as they are removed for future identification. Remove the boost pressure sensor (1) and the intake manifold temperature sensor (2) from the manifold. Remove the wire clamps holding the harness to the manifold. Remove the air intake connection and gasket from the top of the manifold. Remove two of the mounting capscrews and install two guide pins, Part No. 3376488.
Remove the remaining capscrews, beginning at the ends and moving toward the center, intake manifold and gas- ket. Remove the guide pins. Use four (M10 x 25) capscrews and install the front lifting bracket on the rocker lever housing. Torque Value: 47 [35 ft-lb]