Section 0 - Engine Disassembly and Assembly - Group 00 Engine Disassembly (0-01) M11 Page 0-31 Crossheads - Removal Remove the crossheads. Number each crosshead with the cylinder number and position as it is removed. NOTE: Each crosshead must be installed in the same po- sition as it was removed from when the engine is assembled. Injectors - Removal Remove the injector hold down capscrews and hold down clamps. Use injector puller, Part No. 3823579, to remove the in- jectors from the engine. Insert the pin of the tool into the hole provided in the body of the injector. Number each injector with the cylinder number as it is removed. Rocker Lever Housing - Removal NOTE:
Do not drop the capscrew washers into the engine. Remove the capscrews, washers, rocker lever housing, and gasket. Cylinder Head - Removal Remove the seven 12 point capscrews from the camshaft side of the cylinder head. Remove the three capscrews inside the intake ports.