Section V - Specifications - Group 18 Cylinder Block - Rebuild M11 Page V-31 Component or Assembly (Procedure) Ref.No./Steps Metric U.S. Cam Follower Roller Pin (New) O.D. 19.065 mm MIN 0.7506 in 19.073 mm MAX 0.7509 in Cam Follower Lever Socket Bore I.D. 19.024 mm MIN 0.7490 in 19.050 mm MAX 0.7500 in Cam Follower Lever Socket (New) O.D. 19.062 mm MIN 0.7505 in 19.088 mm MAX 0.7515 in Fuel Pump - Rebuild Specifications Gear Pump Shaft Bearing Surface O.D. 12.695 mm MIN 0.4998 in Gear Width 31.707 mm MIN 1.2483 in Gear Installed Depth 17.270 mm MIN 0.6799 in 17.533 mm MAX 0.6903 in Note: Measure from the body end of the shaft.
Body Gear Hole Depth 31.704 mm MIN 1.2482 in 31.712 mm MAX 1.2485 in Body Shaft Bore I.D. 12.733 mm MIN 0.5013 in 12.741 mm MAX 0.5016 in Body Regulator Bore I.D. 9.510 mm MIN 0.3744 in 9.520 mm MAX 0.3748 in