Engine Disassembly (0-01) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-38 NOTE: Some pulleys have an oil seal dust seal installed on the pulley hub. If a dust seal is installed, remove the dust seal from the pulley. The dust seal can be slipped off the hub by hand. Accessory Drive Oil Seal - Removal Remove the five capscrews, clamping ring (1), seal (2), and gasket (3). Accessory Drive Assembly - Removal Remove the six mounting capscrews, accessory drive assembly, and gasket. Crankshaft Pulley and Vibration Damper - Removal Remove one of the damper mounting capscrews and install guide stud, Part No. 3376696 in the hole. Remove the remaining capscrews, pulley, and damper.
Do not use a hammer or a screwdriver to remove the viscous damper. These tools can damage the damper.