Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-50 Engine Assembly (0-02) Cylinder Block - Installation On Rebuild Stand Use adapter plate, Part No. 3376432, with the engine rebuild stand, Part No. 3375194, to assemble the engine. Use ten (5/8 - 11 x 1 3/4) grade 5 capscrews to install the adapter plate to the rebuild stand. Torque Value: 180 [135 ft-lb] Install two guide pins, Part No. 3376488, into the water header plate mounting capscrew holes (1) and (2). The component weighs 23 kg [50 lb] or more. To avoid personal injury, use a hoist or get assistance to lift the component. Use a hoist and engine lifting sling, Part No.
3375957, to lift the cylinder block. Install the exhaust side of the cylinder block to the adapter plate of the rebuild stand. Align the top of the adapter plate (3) with the top row of water header plate mounting capscrew holes (4). The cylinder block must be positioned so two capscrew holes (5) and (6) in the bottom row will show on each side of the adapter plate. Align the guide pins with the bottom row of holes in the adapter plate at points (7) and (8). Use eight capscrews, Part No. 3376434, to install the adapter plate to the cylinder block. Remove the guide pins and install two capscrews, Part No. 3376434. Torque Value:
47 [35 ft-lb] Cylinder Liners - Installation The current o-ring has been produced by two distinctly different manufacturing processes. Following are those two methods and the installation procedures. The molded o-ring has a symmetric cross section. The edges are rounded. It does not require specific care in orientation of the o-ring other than normal prevention of rolling the o-ring.