Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-53 Inspect the liner seating edge for burrs, dirt or dam- age. Replace the liner if it is damaged. Install the liner again. Measure the liner protrusion. If the liner protrusion still does not meet the specifica- tions, use counterbore ledge tool, Part No. 3823558, to cut the cylinder block liner bore for shims. Refer to the Alternative Repair Manual, Bulletin No. 3810310, for the correct procedure. Use a feeler gauge to measure the liner to block clear- ance at the four block casting points. Cylinder Liner to Block Clearance mm in 0.25 MIN 0.010 If the clearance is less than 0.25 mm [0.010 inch]:
Remove the liner.