Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-64 Rotate the engine on the rebuild stand to position the cylinder head mounting surface facing up. Install two guide pins, Part No. 3376697, into the flywheel housing mounting holes of the cylinder block. Apply a 2 mm [1/16 inch] bead of silicone sealant, Part No. 3823494, on the mounting surface of the housing and around each of the mounting capscrew holes. Install the flywheel housing over the guide pins. Install the ten capscrews (M16-2.00 x 55). Remove the guide pins and install the remaining two capscrews (M16-2.00 x 55). Tighten the capscrews to the following value: Torque Value:
7 [60 in-lb] NOTE: This is not the final torque value. The flywheel hous- ing bore must be aligned with the crankshaft. The capscrews will be tightened to the final torque value after the flywheel housing is aligned. Remove the four alignment plate capscrews and the align- ment plate. Flywheel Housing, REPTO - Installation Use four oil pan capscrews (M10-1.50 x 25) and install the flywheel housing alignment plate, Part No. 3376606, to the oil pan flange at the rear of the cylinder block. Torque Value: 47 [35 ft-lb]