Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-68 Use the gauge block, Part No. 3823495, to measure the alignment of the oil pan mounting flange of the housing with the oil pan mounting flange of the cylinder block. The housing flange must be even with the cylinder block flange within ± 0.15 mm [0.006 inch]. If it does not meet these specifications, the bore and face must be realigned. Complete the following steps to tighten the capscrews in the sequence shown: Torque Value: Step 1 - 68 [ 50 ft-lb] 2 - 129 [ 95 ft-lb] 3 - 197 [145 ft-lb] Measure the bore and face alignment again. NOTE:
If the bore and face alignment does not meet the specification, loosen the housing capscrews, tighten the capscrews again, and measure the bore and face alignment again. Remove the barring tool and flywheel housing alignment measuring tool from the crankshaft. Idler Gear (REPTO) - Installation Use Lubriplate W 105, or equivalent, to lubricate the idler shaft o-ring and install the o-ring onto the shaft.