Crankshaft, Main Bearings and Flywheel/Crankshaft wear sleeve CRANKSHAFT WEAR SLEEVE REMOVAL 1. Place and center JDG645E cap screws and driver plate assembly onto crankshaft rear face. Then, using snap ring pliers, set the thinner shoulder of ring tool between sleeve flange and seal case. CD30244 -UN-06MAR95 CD30243 -UN-06MAR95 2. Secure the assembly with a clamp then gradually tighten the screw until wear sleeve is extracted. CTM3274 (01JUL99) 15-14 Saran Liter Engines CD,3274,G15,11 -19-01MAR92 060799 PN=111 FLYWHEEL INSTALLATION NOTE: 3 cylinder flywheels and crankshaft pulleys are unbalanced and therefore are not interchangeable with 4 or 6 cyl. engine parts.
Several unbalance -UN-07MAR95 values are used, take care not to mix parts. Refer to relevant Parts Catalogs to order appropriate parts. 1. Install two guide studs in crankshaft. CD7140 2. Place flywheel on studs and slide into position against crankshaft. IMPORTANT: Always replace flywheel cap screws when flywheel has been removed. 3. Install cap screws and tighten crosswise to 160 N·m (120 lb-ft). CD,3274,G15,9 -19-04JAN99 15 14