Camshaft, Balancer Shafts and Timing Gear Train/Idler Gears and front plate CTM3274 (01JUL99) 20-26 Saran Liter Engines 060799 PN=149 2. Using Loctite® 271 Thread Lock, install injection pump studs (F) on front plate. 3. On standard front plate only, install the 5/16“ plugs (D) and the 3/8” plugs (E) as shown. Bushing (G) is not required for this application. -UN-16JUN98 4. Install oil by-pass valve (B) and spring in cylinder block. (See also LUBRICATION SYSTEM.) CD30600 5. Install gasket (H) and front plate. Place new external tooth washers onto countersunk screws (A) then tighten to 35 N·m (25 lb-ft). 6. Cut off protruding edge of gasket when timing gear cover is tightened.
A—Countersunk screw -UN-04MAY98 B—Oil by-pass valve D—AT21191 Plug (5/16“) - Qty: 6 E—AT22919 Plug (3/8“) - Qty: 2 F—Stud G—R79854 Bushing (not required for this application) CD30598 H—Gasket J—Front plate -UN-19MAY98 CD30597 LOCTITE® is a registered trademark of Loctite Corporation. CD,3274,G20,49 -19-04JAN99 20 26