Camshaft, Balancer Shafts and Timing Gear Train/Auxiliary drive (crankshaft-gear-driven) OUTPUT SHAFT COVER INSTALLATION 1. If studs (A) are used, apply sealant to threads of stud (timing gear cover end) and install in cover. 2. If the four threaded holes (B) are not used, apply a thread sealant to the set screws then install them up to a recess of 0—1.0 mm (0—0.04 in.) from flange surface. RG5182 -UN-06DEC88 3. If front and/or rear cover plates for output shaft are used, install using new gaskets. CD,3274,G20,42 -19-01FEB94 20 38 CTM3274 (01JUL99) 20-38 Saran Liter Engines 060799 PN=161