Cyl. Block, Liners, Pistons & Rods/Cylinder block INSTALLING CAMSHAFT BUSHING IMPORTANT: Bushing must be installed so oil supply hole (arrow) aligns with oil drilling in block bore. 1. Apply TY6333 grease* to internal diameter and outside diameter of bushing. CD30389 -UN-10MAY95 2. Slide bushing onto driver so notched end (A) of bushing will be toward front end of engine when installed. 3. Tighten forcing screw until flange of driver bottoms against face of block. *Available as service part. CD,3274,G10,49 -19-01FEB94 CTM3274 (01JUL99) 10-15 Saran Liter Engines 060799 PN=76 REMOVE CAMSHAFT BUSHING -UN-10MAY95 -UN-17FEB95 CD30388 CD30340 Extract camshaft bushing using JDG739B tool as 2.
Insert bushing puller (D) into camshaft bushing follows: bore. 1. Assemble threaded spacers (A) and forcing plate 3. Tighten hex. nut until bushing is free of block bore. (B) to cylinder block (C). CD,CTM125,051 -19-01DEC97 10 15