PERIODIC SERVICE 44 B Cleaning Radiator Screen B Checking Engine Cooling Fan [For those of the engine serial number 8U0086 or later, check the fan operation.] To avoid personal injury: A Be sure to stop the engine before removing the screen. To avoid personal injury: A Do not stick your finger in the fan operating section when performing visual check. A Wear protective equipment when performing visual check. A Never start engine while standing on the ground. Start engine only from the operator's seat. 1. Park the vehicle on a flat surface and raise the seat. 2. Detach the screen and remove all foreign materials. 1. Park the vehicle on a flat surface and apply the parking brake. 2.
Start up the engine. 3. After starting up the engine, get off the operator's seat and hold up the seat to visually check that the fan is operating. 4. The fan should come on 5 sec. after starting engine and operate for 10 sec. 5. If the fan will not operate, do not operate the vehicle but consult with your dealer. (1) Radiator screen (A) "DETACH" A Radiator screen must be clean from debris to prevent engine from overheating. [Exceptions in Operation] A If the engine coolant temperature is higher than 87 ( 87 ) at startup, the fan will turn on immediately and run until the engine coolant temperature is less than 80 ( ).
A When the water temperature sensor is in trouble, the fan start operating. A If the engine startup is failed, return the key to the "OFF" position (ENGINE STOP POSITION). (1) Engine cooling fan