69 PERIODIC SERVICE EVERY 4 YEARS 4. Check the brake pads for wear or damage. Check the pad's thickness: Minimum thickness should be 1mm (3/64 inch). If below this or pad material is damaged, contact your local Kubota Dealer. B Replacing Brake Hose Consult your local KUBOTA Dealer for this service. SERVICE AS REQUIRED B Checking Brake Pad To avoid personal injury: A The machine can fall or slip from an unsafe device or supports. A Use a safe lifting device rated for the load to be lifted. A Lower the vehicle onto jack stands and block the wheels before servicing. (See "JACK-UP POINT" in "PERIODIC SERVICE" section.) 1. Park the vehicle on a firm, flat and level surface. 2.
Raise the vehicle with a safe devise and lower onto the jack or other stable supports. Block the wheels remaining on the ground to prevent the vehicle from moving. 3. Remove the wheel bolts and the tires. (1) Brake pad 5. Reinstall the tires with the valve stem to the outside. 6. Tighten the wheel bolts evenly in alternating sequence until snug. 7. Repeat the same procedure for remaining three tires. 8. Lower the vehicle completely to the ground. 9. Tighten the wheel bolts from 108.4 to 121.9 N-m (80 to 90 ft-lbs). B Adjusting Parking Brake For proper adjusting of the parking brake, consult your local KUBOTA Dealer.
B Adjusting Alternator Drive Belt Tension For proper adjusting of the alternator drive belt, consult your local KUBOTA Dealer. (1) Wheel bolts