10 Fieldwork settings 10.2 Feeder unit 67086 10.2 Feeder unit 82118 10.2.1 Adjusting the cutting height indicator The sender (1) for the front attachment cutting height display on the right feed rake conveyor side must be adjusted. It shows the front attachment cutting height above the ground. Prepare fieldwork. Check the cutterbar float springs. Start the diesel engine. Switch on the road travel / fieldwork switch. Lower front attachment until the skids are 100 mm above the ground. Observe the general warnings at the beginning of the "Fieldwork settings" chapter. Slacken off bracket (2) and adjust it so that the pointer on the cutting height indicator (A) stands at the mark (9).
Bolt down bracket (2). 1 2 1 19602 9 A B 2 19601 79341 10.2.2 Adjusting the scraper profiles The scraper profiles influence the material flow in the feed rake conveyor. The scraper profiles must be set for grain or maize. Observe the general warnings at the beginning of the "Fieldwork settings" chapter. Warning! Sharp edges and pointed machine parts. Slight injuries. Wear safety gloves. 1 3 19521 If required, turn scraper profile (1) at the feeder unit and bolt down hand-tight. Fit front attachment to the machine. Adjust scraper profile (1) according to the front attachment scraper profile and bolt it down.
174 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 Crop Scraper profile bolts down to feed rake conveyor with Grain narrow leg Maize wide leg