10 Fieldwork settings 10.3 Threshing mechanism 67086 10.3 Threshing mechanism 82451 10.3.1 Removing / installing threshing con- cave segments (Multicrop concave) The concave segments must be installed specifically for the crop to be harvested. See threshing chart, see specifications Lower the feeder as far as possible. Observe the general warnings at the beginning of the "Fieldwork settings" chapter. Set the threshing concave downwards. Open flap and unscrew cover (1). Unscrew bolts from the concave segments. 1 8 19619 Note! 3 Constructive conditions. Facilitation of assembly. First remove the centre segment. Then push the outer segments slightly to the centre and remove them.
Clean the segment guides in the concave prior to installing the segments (3). Insert segments and bolt them down. 19621 9 82206 10.3.2 Adjusting the basic concave adjustment Observe the general warnings at the beginning of the "Fieldwork settings" chapter. The clearance of the threshing concave on the right and left sides must be parallel. 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 177