13 Maintenance 13.2 General Information 67089 To achieve even grease distribution, let the machine run briefly after greasing until a small grease edge has formed at the outside of the bearings. Before and after cleaning the machine with a high-pressure jet cleaner, the bearings must be greased! With the combine still running, operate the varia- ble-speed drives to distribute the grease evenly between the sliding parts. Coat the inner flanks of the variable speed pulleys with corrosion inhibitor as far as possible. Remove preservation before putting the machine into operation the next time!
Seal off peripheries of slip clutches with paint to keep moisture out and to keep friction faces from rusting. Grease all polished parts such as finger bars and crop lifters. Carry out all maintenance work according to the specified intervals. Check machine prior to cleaning. Have repairs carried out if necessary. Store the machine in a dry, weatherproof shed where no fertilisers are stored! Lower the front attachment to the ground or remove it in order to relieve the hydraulic system. Jack up the machine so that the full weight is not resting on the wheels. Check the coolant antifreeze content.
Charge the battery and recharge every six weeks or leave it with a battery service point to take care of. 12884 13.2.20 Coolant The engine cooling system has been filled with a mix- ture of corrosion / frost protection and water at the factory. The coolant consists of 50% corrosion / frost protection and 50% water. This ensures frost protection down to approx. -37 °C. Also refer to the specifications of the engine manufacturer. 268 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09