198 Hydrostatic drive system X Connection to the front end: open the front flap ( Y page 291). X Insert the cable of the equipment camera to the open end of wire ; and tighten the electrical screw connection. X Position the device camera in a suitable position on the attached equipment. X Secure the cable of the device camera with a cable connector. X Guide the cable of the device camera under the front flap. Make sure that the cable is laid without tension, kinking or friction. Switching the equipment camera on/off X Unscrew electrical screw connector : , ; and separate. Driving mode X Insert the cable of the device camera and twist the electrical screw connection tight.
X Unscrew protective cap ? at the open end of wire = . X Reconnect electrical screw connection ; , = and close. X Connect protective cap ? to the open end of wire : and screw closed. X Secure the cable of the device camera with a cable connector. X Make sure that the key is in position 2 in the ignition lock. X Close the front flap ( Y page 291). X To switch on: press button : . X To switch off: press button : again. Hydrostatic drive system General notes The hydrostatic drive system supports you during working operation where vehicle speeds are low, e. g.: R road works X Rear area connection: position the device camera in a suitable position on the attached equipment.
R trench digging The hydrostatic drive system can separate the speed of the diesel engine from the vehi- cle speed. As such, the drive speed is deter- mined at the PTO shaft and the working and power hydraulics are independent of the vehi- cle speed. You can accelerate your vehicle, starting from a standstill, up to the applicable maximum speed of the gear. This high gear ratio spread means you need to shift gears less often. If a gear change is necessary, the clutch does not need to be opened since no- force shifting is performed by the hydrostatic transmission. For this reason, in vehicles with R snow clearing X Unscrew protective cap : at the open end of wire ; and remove.
X Guide the cable of the device camera into the rear area and connect it. Make sure that the cable is laid without tension, kinking or friction.