Hydrostatic drive system 203 If necessary, you can also activate working mode cruise control and the work limiter ( Y page 203). to adjust the vehicle speed with the working mode cruise control and to set the working speed separately. Driving mode Hydrostatic drive system status indicator : Working mode cruise control display ; Drive condition display = Work mode display Working mode cruise control status indicator : Working mode cruise control deactivated ; Working mode cruise control activated = Stored speed cannot be reached (red arrow) ? Speed reduced by the driver (blue arrow) When work mode = is activated:
R the previously selected working speed is set To switch between "work" mode = and "drive" mode: R the previously selected gear is selected Even if working cruise control is activated, you can reduce your speed by braking gently. When doing so, the stored speed will not be altered. A blue arrow appears in status indi- cator ? . If you then step down on the accel- erator pedal, you will return to the stored speed. If you wish to drive faster than the stored speed, you must briefly release the accelerator pedal and then press down on it once more. If a red arrow appears in status indicator = , the vehicle speed is lower than the stored speed.
The speed of the diesel engine remains the same, however. The reason for the lower speed could be: X To use the multifunction lever: briefly press the o button on the multifunction lever. X To use the control lever: make sure that the Work Drive function is selected in the on-board computer ( Y page 241). X Press the blue button on the control lever. Working mode cruise control with work limiter R uphill/downhill inclines R the engine speed is too low Working mode cruise control R an unsuitable gear is selected Working mode cruise control is a special cruise control that can be used in "work" mode. Working mode cruise control can be activated within a speed range from 0.1 km/h up to 25 km/h.
You can set the speed your- self in 0.1 km/h increments. Working mode cruise control is suitable, for example, for mowing on a slope. It is possible R the operating temperature is too high Z