Menus and input windows in the on-board computer 237 Hydraulic system Operation using the control lever X Make sure the vehicle is stationary. X Press black button ? . The Working functions menu appears. The Hydraulics input window is selected. X Press black button ? . The Hydraulics input window appears. X Select the entry, change the value and con- firm the function ( Y page 235). Hydraulics input window, vehicles with gear pump (example) : Symbol for working hydraulics circuit I:
continuous consumer on red hydraulic connection 1, continuous consumer on green hydraulic connection 3 or snow plough load relief ; Flow rate for continuous consumers or load relief function value for snow plough load relief = Flow rates ? Symbols for the working hydraulics circuit and power hydraulics circuit "Hydraulics" input window G DANGER A vehicle with positioning pump has equip- ment with a constant flow rate connected. If you then select LS in the "Hydraulics" input window, the attached equipment goes into float setting as soon as you activate the cor- responding working circuit. The equipment fitted then lowers in an uncontrolled manner.
Persons in the area of danger can be seriously or even fatally injured. Keep the following in mind before activating the working hydraulics: in the case of attached equipment with a constant flow rate, a flow rate must always be shown in the "Hydraulics" input window, and not LS . Z Structural sequence in the on-board com- puter Display Operation and main- tenance â Hydraulics Working func‐ tions Hydraulics The hydraulics input window appears.