Working hydraulics circuit II 253 sumer has a coloured border. The continu- ous consumer is in standby mode. or X Turn the key to position 1 in the ignition lock. or X Continuous consumer to green hydrau- lic connection 3: press button P . The indicator lamp in button P flashes. The Hydraulics input window opens in the on-board computer. Green hydraulic con- nection 3 for continuous consumer Z is selected. The symbol for the continuous consumer has a coloured border. The con- tinuous consumer is in standby mode.
working hydraulics circuit II, vehicles with gear pump Working hydraulics circuit II Activating/deactivating working hydraulics circuit II i As described below, you can confirm your selection with the 9 button on the steering wheel or with the black button on the con- trol lever. Hydraulic system X To change the flow rate: using the u or t button, increase or decrease flow rate \ . Switching on continuous consumers X Press the 9 button on the steering wheel or the black button on the control lever until the indicator lamp in button Q or P lights up. The corresponding continuous consumer is switched on. The symbol for continuous consumer Z is coloured. !
Only switch on the hydraulic system when it is connected to an item of attached equipment. There is otherwise a risk of damage to the hydraulic system. Switching continuous consumers back to standby mode X Call up the Hydraulics menu window ( Y page 237). X Using the r or s button, select cor- responding continuous consumer Z . X Press the 9 button on the steering wheel or the black button on the control lever until the indicator lamp in button Q or P flashes. The symbol for continuous consumer Z has a coloured border. The continuous con- sumer is in standby mode. Switching off continuous consumers X Press button Q or P . The indicator lamp in button Q or P goes out.
or X Switch off the hydraulic system ( Y page 230). Z