Equipment operation 265 Transmission-driven power take-off event window of the on-board computer for approximately two seconds. The I indicator lamp in the status area of the on-board computer and indicator lamp ; in the switch light up. Vehicles with Telligent ® automatic gear- shift: the transmission-driven power take- off turns. With a gear engaged, the trans- mission-driven power take-off only turns when the vehicle pulls away. General notes The transmission driven power take-off can be operated:
R when the vehicle is stationary R when the vehicle is driven forward in 1st to 4th gear R when the vehicle is driven in reverse in 1st to 5th gear The transmission driven power take-off can also be activated if the working gears ( Y page 182) or the crawler gears ( Y page 184) are engaged. X Vehicles with Telligent ® gearshift: slowly release the clutch pedal and pull away. The transmission-driven power take-off turns. Engaging/disengaging the transmission- driven power take-off ! When power take-off is activated, you must only change gear when the vehicle is stationary. The transmission may other- wise be damaged. X All vehicles:
observe the general notes on engine speed mode ( Y page 262). Working mode X Activate constant working speed ( Y page 263). X To disengage: press switch = . The I indicator lamp in the status area of the on-board computer and indicator lamp ; in the switch go out. Engine-driven power take-off ! Engine-driven power take-off may only be activated when the engine is at a standstill. Engine-driven power take-off is mostly used for power hydraulics. It can, however, be used for other attached equipment (e.g. pump drives). When automatic regeneration of the diesel particle filter is carried out, the engine speed is increased. X To engage:
ensure that the engine is run- ning and the vehicle is stationary. X Vehicles with Telligent ® gearshift: depress the clutch pedal. X Vehicles with Telligent ® automatic gearshift: shift the transmission into neu- tral. X All vehicles: press switch : . Indicator lamp ; in the switch flashes for several seconds. Engaging the transmis- sion-driven power take-off occurs after a few seconds. If power take-off is engaged, the corre- sponding display message appears in the