Information on the compressed-air reservoir 379 Information on the compressed-air reservoir prevent corrosion or mechanical damage from occurring. Tensioning straps are to be positioned in such a way that they do not come in contact with the base con- necting seams; the reservoir is not to be subjected to any stress that would jeop- ardise operating safety. Coatings applied to aluminium reservoirs must not contain lead, and the top coat of paint must only be applied over a suitable primer coat. Steel threaded connections for aluminium reservoirs must have a cor- rosion-proof coating. only to be cleaned using non-alkaline cleaning agents (aluminium reservoir).
to have the interior visible through the threaded connections. to be emptied at regular intervals to pre- vent the accumulation of condensation (drainage ring nut at the lowest point of the reservoir). e to require no maintenance if Item d is complied with. no welding, heat treatment or other oper- ation relevant to safety is to be per- For first-time buyers and other users Accompanying documentation in accordance with directives 87/404/EEC and EN 286-2 The reservoir is: Technical data only intended for use in compressed-air systems and auxiliary equipment on motor vehicles and their trailers, and is only to be used to hold compressed air.
b to be marked for identification with a works number and the reservoir manu- facturer’s name, together with the prin- cipal operating data and the EC mark – see the identification plate or engravings directly on the reservoir wall. manufactured under a "Declaration of conformity" in accordance with Arti- cle 12 of Directive 87/404/EEC. d to be secured to the vehicle by tensioning straps (clamps). In the case of aluminium reservoirs, con- tact surface points must be designed to 10 Depending on the equipment mounted, an overall width of 2550 mm is possible. 11 Without rotating beacon or strobe light.
Z Vehicle type U 527 K / U 530 K U 527 L / U 530 L B Trailer coupling height 869 mm 869 mm C Frame height at rear 1141 mm 1141 mm D Load platform height 1435 mm 1435 mm E Dropside height 406 mm 406 mm F Ground clearance Approx. 379 mm Approx. 379 mm G Overall width10 2300 mm 2300 mm H Overall height11 2900 mm 2900 mm I Track width 1828 mm 1828 mm Diameter of turning circle Approx. 15.1 m Approx. 16.9 m Platform internal dimensions 2650 x 2200 mm 3430 x 2200 mm